ok guys, before i bought my new keyless entry remotes i tested the the keyless entry module by jumping the A and G ports on the DLC. The locked cycled and evey thing worked. I got my remotes in today, and i go to jump the A and G ports and nothing happens. What the hell?? So, do i need to reset the PCM before i the keyless entry module will go into pairing mode or what. Any help is greatly appreciated!!

 

nevermind guys, the paperclip i was using didnt want to work. I finally got mad and used a piece of wire and it worked. The only problem now is the Lock button doesnt lock the doors. Every other button works fine. Any ideas?

 

anyone?

 

iv had this problem before, i reset the computer and went through the programing process again. It worked for me. Also check to see if the battery isnt dead lol

 

the lock button didnt work for you either? nah my batt is good. Optima redtop.

 

no it didnt work for either remote until i reprogramed it. since then i havnt had ne more problems. if that doesnt help i dont know any other solution. good luck

 

thanks, i appreciate it!