Comp. port not working...
#1
Teching In
Thread Starter
iTrader: (1)
Join Date: Dec 2005
Location: St.Peters MO
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
Comp. port not working...
I went to plug my scan tool in and it will not turn on. So i went to plug the tool in to my truck it works fine. Ive checked all of the fuses but can not figure out whats going on. Here is the car info.
1996 T/A
Stock comp.
Did the wire mod
Any help with this would be help full. Everything was working fine and i let it sit most of the winter now this is happening.
1996 T/A
Stock comp.
Did the wire mod
Any help with this would be help full. Everything was working fine and i let it sit most of the winter now this is happening.
#6
12 Second Club
iTrader: (35)
Join Date: Jan 2006
Location: Danville PA
Posts: 1,550
Likes: 0
Received 0 Likes
on
0 Posts
Your Diag port is tied in with your Cigarette lighter. Check to see if your lighter works. If it doesnt, check the fuse on in the fuse block on the drivers side on the interior. Replace it. If it blows again, then there is most likely something wrong with your cigarette lighter. Unplug the entire Cig. unit and replace fuse. That should get you power to your port....