Electronic cutout
Thread Starter
TECH Senior Member
Joined: Jun 2003
Posts: 9,339
Likes: 3
From: NYC metro area
Electronic cutout Sup guys, can somebody get me a good link for a GOOD electronic cutout? I've wanted a cutout for a while, but I really wanna go with an electronic one. However, a buddy of mine told me that the electronic ones tend to gum up and get stuck... Anybody have any experiences? Thanks for the input. 
On The Tree
Joined: Mar 2002
Posts: 154
Likes: 0
From: Birmingham,AL
I bought a Borla that had an electric cut-out from DMH Performance in Ohio. It goes where the block off plates would normally go. Problem with these is sometimes the motors burn out. This one was fried, thankfully it was replaced. The new instructions say to be careful to not hold the switch too long or it can cause overload on the motor and cook it. I can't wait to put it on in the Spring. Good Luck.
