Sup guys, can somebody get me a good link for a GOOD electronic cutout? I've wanted a cutout for a while, but I really wanna go with an electronic one. However, a buddy of mine told me that the electronic ones tend to gum up and get stuck... Anybody have any experiences? Thanks for the input.

 

http://www.quicktimeperformance.com/qtec.htm

Ive had mine for over a year with 0 problems so far.

 

I bought a Borla that had an electric cut-out from DMH Performance in Ohio. It goes where the block off plates would normally go. Problem with these is sometimes the motors burn out. This one was fried, thankfully it was replaced. The new instructions say to be careful to not hold the switch too long or it can cause overload on the motor and cook it. I can't wait to put it on in the Spring. Good Luck.