the_merv

iTrader: (88)

Looks good guys.

Kory 88Iroc Lt1

iTrader: (7)

Are you guys using aluminum pipe for this?
Thanks,
Kory

Colin91Z

iTrader: (9)

It's steel. I couln't find anything with the correct bend in aluminum, I would have prefered to have used either aluminum or plastic.

Turnin20s

iTrader: (12)

Agreed, I'm still looking and if I find anything I'll post it up

Colin91Z

iTrader: (9)

Sounds like a plan

FASTFATBOY

iTrader: (23)

http://www.verociousmotorsports.com/...-Mandrel-Bends

Johnny-LT1-runner

iTrader: (15)

That link is effin beautiful. lol

Colin91Z

iTrader: (9)

Thanks for the link, I didn't see any 60* bends though. I know from experience that 45* and/or 90* will NOT work. I may call that place and see of they can come up with a 60*...

FASTFATBOY

iTrader: (23)

Do a google for "Aluminum exhaust bends", there are a good bit more to offer.

Wicked94Z

iTrader: (26)

just picked up a stock intake from a C6Z, looks like the angle is about right and it would clear a lot better than a 3.5" oval pipe. im running speed density so its a little easier for me, im gonna run a drop in filter and see how it does. it was free why not

Phstratton

iTrader: (1)

Im about to do this and my question still stands, how did you design the radiator support?

Ls1~Lover

iTrader: (5)

I hate to bump a old thread, But does anyone know how much tubing i will need like the whole length of it?
Like for example the spectre pipe looks like its just the part where it bends..

1slo_camaro

iTrader: (2)

Bringing this back up.... Has anyone else done anything along these lines?

moderate Z28

I did it recently. I like it. Looks cool. You can really hear the air sucking in.

smitty2919

Unlike everyone else, I kept A/C.

bufmatmuslepants

iTrader: (3)

Has anyone ever done this with a universal cold air intake or a piece of silicone 60 degree bend elbow? Also has anyone successfully done it using any corvette parts? I hear they are not enough of a bend radius.