jays97 t/a

iTrader: (2)

finally going to the track in dayton ohio tomorrow..im hoping to get some mid 12s with my AI cam only car..will post results tomorrow

jays97 t/a

iTrader: (2)

well i could only get one pass in and i got a 13.5 at 104 with a 2.3 60ft and the 8th was 8.6 at 84...i kno my 60ft was horrible but i figure if i actually hook up i could get a 12.5

jays97 t/a

iTrader: (2)

the last time i went to the strip i went to an 8th mile track and my car only had stall exhaust and tune with the drs i got a 1.8 60ft and 8.78 at 77 so i def gained some hp with headers and cam kit

TravisMcGill2000

iTrader: (2)

i know your 60ft was bad but that trap is really low. I trap 106-107 with boltons

StealthFormula

iTrader: (35)

Something is seriously wrong with your trap. With only LT's and a catback I trapped that. I don't know the size of your cam but I would expect in or around 110mph.

What is the size of the cam? Where are your shiftpoints set to? Could simply just be not shifting the car high enough, that will kill mph.

jays97 t/a

iTrader: (2)

Ai 226 234..its shifting at 6300rpms and i think the stock tach is off by acouple hundred so probably 6100

WhitePhoenix99

iTrader: (12)

Well the 2.3 60ft is hurting your trap. . I wouldn't even have bothered without having drag radials with a stalled, cammed car. Get some tires and I think you'll be a lot closer to your goal of mid 12's.

BSmiff

Definately need to get that 60 down. Even at full weight a stalled cammed car should cut at least a 1.8.

myltwon

iTrader: (1)

doesn't mater what he 60's the power is not there in the mph, his biggest concern should be where is his power at not traction imo

AChotrod

iTrader: (17)

I agree a terrible 60ft usually nets the same if not more MPH in the 1/4.
I hate to say/ask this but is there any good running AI cam only cars on this site??

On the bright side I think the car could go 12s even with that MPH.

CamaroRacing12

iTrader: (5)

(see my sig)

i run mid 12's with that sort of trap time. but depending on DA and altitude i would think ur trap time would be higher also.

myltwon

iTrader: (1)

trap is basically a measurement of power-to-weight and et is the ability to utilize it.

you are trapping 3mph higher with bolt ons vs his cammed car. only thing I can think of his track elevation is pretty crazy or there is something wrong with the car

pyro719

iTrader: (5)

Dayton Ohio elevation 738 ft . Is the car tuned? Shift points Shouldbe higher with that cam.

myltwon

iTrader: (1)

where did it stop making power at on the dyno? I'd imagine that cam would want to rev to atleast 6400rpm

CamaroRacing12

iTrader: (5)

he could be heavy

AChotrod

iTrader: (17)

real heavy......

myltwon

iTrader: (1)

like a vert riding 4 deep

AChotrod

iTrader: (17)

with a full tank of gas....

myltwon

iTrader: (1)

with a dead hooker in the trunk...

97Z28SS

iTrader: (5)

Put some more gear in the car, 3.73's if it's an a4 or 4.10's if it's an m6.