Theres a car i found and im going to look at it tomorrow. I was just wondering about what kind of numbers this car should be putting down?

350 new rings and bearings, cc306 cam (510 540 lift) ported heads and intake, 1.6 roller rockers, new springs and hardened pushrods, longtube headers, 3 inch ypipe with flowmaster cat back, spec 2 clutch,

http://kansascity.craigslist.org/cto/1431934621.html link to the car.

 

Well depending on the ported heads and who ported and how well they are ported with that cam and Who tuned it. Anywhere from 320-370 rwhp Id say, but thats a gamble if all was installed correctly and the tune is spot on. The head flow is very important on this too.

 

285-315 rear-wheel?

 

Around what times should this run in the 1/4? I was thinking low 13s?

 

if done right and with sticky tires low 12s to high 11s

 

Maybe with just his bolt-ons...

I thought the CC306 was capable of putting down 350+rwhp with stock heads...

 

It is. My buddies puts down 373rwhp w shitty ported heads

 

t56 car with cc306 and a good tune should make around 345-360rwhp, trap around 110-113mph