After the install of FreeScan, i try to open it up and this is what pops up "the system can not find file specified"... Did I do something wrong? I uninstalled and redownloaded it and I'm still getting the same thing... After i click 'OK' it goes into the program. Im about to go out side and try it again. The first time i tryed it; didnt pull any codes which my SES light is on, also the only thing in the 'Dash Board' function working was the tach, everything else was not working... Anyone have any of these problems : (... Please help...

 

Check the "comport" mine was wrong when i first installed it

 

Did you select the type of car you have?

Did you turn on the key to ON for 5 seconds, and did the program receive any bites from the PCM?

You should visit Solomon's site, he has a little write up on how to do it. Search google for lt1 pcm tuning, you should find it in the free tips section.

 

Try Datamaster instead.

www.ttspowersystems.com

 

comport was good it was port4, I was running DM too and i didnt think it was working at first but it pulled alot of codes im putting a thread up of my book of codes i pulled right after this.. please check out.. I threw 58 codes!!! thats got to be a record or something is just wrong. I didnt think DM can pull codes? Ill try solomans site and see what i can get myself into ..

 

Wow 58 codes, yeah, you definitely need tuning LOL! With Freescan make sure you select your vehicle, I had the same problem when I first tried it.

 

58 codes... that's practically every single code in the book. I don't think that's possible.

 

He was reading it wrong...

 

lol must was reading all the green instead of the red lmao....

 

TTS is so much easier to use, and reads a lot of info real time that you can monitor.