ORY hitting torque arm and fuel lines
Thread Starter
TECH Apprentice
Joined: Mar 2007
Posts: 328
Likes: 1
From: coral springs FL
ORY hitting torque arm and fuel lines I finally had my pacetters LT with and ORY installed after fixing a blown head gasket. the ORY is touching the fuel lines pretty bad and is also rattling with the torque arm. the part that is suposed to be passing under the fuel lines is smaller to allow the lines to run without being to close to the ory but I guees this is not enought. should a hammer fix this 
I finally had my pacetters LT with and ORY installed after fixing a blown head gasket. the ORY is touching the fuel lines pretty bad and is also rattling with the torque arm. the part that is suposed to be passing under the fuel lines is smaller to allow the lines to run without being to close to the ory but I guees this is not enought. should a hammer fix this
Mine wasn't touching but was close enough that it bothered me. I used a little header wrap on a few inches of the y-pipe and used some heat reflective wrap on the fuel lines.
