suicidal racing

iTrader: (14)

thanks...got my a/c delete pulley comeing,bullets and headers..now i just got to figure out what i want to do next....only got 200$ left to spend right now though..lol

thinking about doing the coil rubber hose mod to drop the rear,race seat an brackets..

i cant do the coolant bypass because its in the 20s up here..im pretty much down to weight mods right now..lol

i probley should just swap springs and get roller rockers...anyone know if i really have to use self alligning rockers for these or can i just grab a std set..?

suicidal racing

iTrader: (14)

heres some pics of my old 93...i havent loaded up any of the 94 yet..my inside will be the same setup for gauges..i really liked it before and will be doing it again
the slicks always leaked..lol

tomcowle

iTrader: (5)

Are those the worlds smallest set of rear slicks or what on your old car?

What did it run?

djjab57

iTrader: (17)

I thought the car is just sitting super high up Look at the ground clearance

djjab57

iTrader: (17)

Nevermind i see the jack stands now

suicidal racing

iTrader: (14)

haha tom..them are 26x10s on the back..they look tiny in a non dropped rear lt1...it ran 6.50s in the 1/8th on a 150 shot..the stall and rear gear was wrong and there was an easy 200#s of **** that could of been pulled so the car was around 3300 or more..only had bmr tq arm,9",air bag and frame connectors an had a best of 1.44 60ft..with stock everything else..i never did put the real engine in her..the car runs outlaw dr in florida now an has been a 8.25 with a mild 2 stage 540

suicidal racing

iTrader: (14)

the new ride..ill turn this into my build thread..but i wont be doing much till i can get a warm day really seeing it was a low of 8 last night and high 20s today..hopeing for a 40 degree day to do the header,exh,ac delete and heat box mod.