AChotrod

iTrader: (17)

Thanks,
Yes its temporary for now. Not sure what Im going to do though just yet.

AChotrod

iTrader: (17)

The MSD plug and play harness some wire and a momentary button to activate it.

SoxXpupPeT

iTrader: (34)

msd part # 8876 < thats the plug and play harness for lt1's

really ? where are you going to finally mount it ?

AChotrod

iTrader: (17)

If I get someone over with wiring skills Ill have them hook it up to the radio controls on the factory wheel, or maybe get a new aftermarket wheel with a built in momentary button. Just dont like the zip ties that hold it on now.

gregrob

iTrader: (8)

Actually there are two part numbers for lt1s. 8876 is for the DUAL connector coil that 92-95 has (i think that's the years) 8877 is for the single connector coil used in the later years.

SoxXpupPeT

iTrader: (34)

lol ok i thoguth you were talking about the box itself being temporarily mounted there. im a dumbass having it on the wheel is real nice tho. i wont be able to do that without something fairly custom with my grant wheel tho...


very true i forgot to mention that. thanks for the clarification!

LT1forever

iTrader: (4)

So no MSD blaster coil is required with this box? Sorry for the dumb questions. I just want to be exactly sure on what I need for something I know little about.

AChotrod

iTrader: (17)

I run a stock coil.

AChotrod

iTrader: (17)

The box stays where its at. Drill a hole in the grant wheel for a momentary button.

collier341

iTrader: (5)

Sweet install man. It fits perfect there. How come it's upside down though??


EDIT: I see the controlls on the bottom now. My bad.

SoxXpupPeT

iTrader: (34)

i dont think you would need one. but it couldnt hurt. if you have one already tho its fine.


i would if my wheel was a POS but its just to pretty hahah ill figure it out one day. i have to much other stuff going on to worry about that as of yet. but thanks!

Thanks! the 6AL-2 is alittle bit smaller then the old 6AL and when i saw that spot i figured itd be perfect for it. and sure enough it was lol

AChotrod

iTrader: (17)

Do something like this. It will look sweet!
http://www.burkhartchassis.com/id86.html

SoxXpupPeT

iTrader: (34)

that would look really sharp and would be the perfect spot but unfortunately my grant wheel doesnt have any holes in it lol

LT1forever

iTrader: (4)

[QUOTE=SoxXpupPeT;13193164]i dont think you would need one. but it couldnt hurt. if you have one already tho its fine.

Are you running the 6 AL 2 box by itself?

SoxXpupPeT

iTrader: (34)

^^ the box is just an add-on to the already functioning ignition setup

MattSapp95_T/A

iTrader: (35)

I have that same wheel in my 95 Trans Am and I have my momentary button in the same hole...works really well and looks good!


I Very nice install on the MSD box!!

Matt