Catch Can?
Why do you need a catch can are you boosted?
On my rearmount LT1 I don't a puke can one since it is low power and boost is ~14 psi.
I have one that was fabbed for my drag car. The drag car also needed tall valve covers and I may use an evacuation system from the exhaust. Short term I will try adding a second puke line. The taller valve covers are easier to work with since getting fittings on the stock valve covers is a bit of a problem.
I haven't had any problems <16 psi
Good luck
On my rearmount LT1 I don't a puke can one since it is low power and boost is ~14 psi.
I have one that was fabbed for my drag car. The drag car also needed tall valve covers and I may use an evacuation system from the exhaust. Short term I will try adding a second puke line. The taller valve covers are easier to work with since getting fittings on the stock valve covers is a bit of a problem.
I haven't had any problems <16 psi
Good luck
My buddy has made a few using air compressor filters. If you go to Home Depot/Lowes etc. you can buy one of those filters along with fittings for ~$30. Then go ahead and buy a couple feet of the correct diameter fuel hose and your good to. Here's what they look like, the same size as your typical catch can:
