crank hub sleeve
Thread Starter
Launching!
Joined: Jan 2010
Posts: 238
Likes: 1
From: Nashville
crank hub sleeve I'm going to be installing a sleeve on the crank hub tomorrow and need some ideas how to put it on. I don't have access to a press so gotta go a different route. Friend told me to place the hub in the freezer and the sleeve in the oven. His theory is the hub will shrink and sleeve expand making it easier to install. Makes sense but sounds too easy lol. Any ideas?
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Five Reasons the Camaro Was the Most Pivotal Player in the Pony Car Wars 2.0
Brett Foote
10 Reasons the LS7 Is GM's Most Extreme Naturally Aspirated V8 Engine Ever
Verdad Gallardo
Thread Starter
Launching!
Joined: Jan 2010
Posts: 238
Likes: 1
From: Nashville
Was extremely easy to install. I put the hub in the freezer for 20 mins and put the sleeve in the oven @ 250 for 20 mins. Pulled both out and installed in seconds. After installing when you pull the flange off make sure there are no burs or it will slice the seal. Other than that easiest thing I have done so far lol.
