t56 conversion

Reply Subscribe

Thread Tools

Search this Thread

Jun 17, 2010 | 11:36 AM

hbmtexas

Thread Starter

Teching In

Joined: Oct 2009

Posts: 6

Likes: 0

t56 conversion

sorry guys i kno thers a thread about this but i cant find it ok im trying to to the conversion and i was wondering can i use any parts of a v6 99 camero like the pedal assembly and slave cylinder and so on i have a 97 ta i kno that trans are differnt but i just need the interior stuff can anyone help

Jun 17, 2010 | 01:14 PM

JB_97ws6TA

TECH Fanatic

iTrader: (6)

Joined: Oct 2007

Posts: 1,118

Likes: 0

From: Central Valley, CA

I am 99% sure that the pedals are the same, I would not gamble with used hydraulics. You can get the new, pre-bled from GM for less than $200.

Jun 17, 2010 | 01:17 PM

96lt1m6

TECH Junkie

iTrader: (31)

Joined: Jan 2006

Posts: 3,782

Likes: 3

From: LA$ VEGA$

It will make life easier to get all parts from the same type. 94-97 93s are geared differently....
pedal assembly will work however you will need the hydraulics from an Lt1 car
M6 X-member
93-97 hydr. www.ws6store.com
93-97 bellhousing
93-97 flywheel
87-97 pilot bearing
93-97 T56 tranny
retune pcm for manual trans
manual trans boot
upper console for manual trans

Jun 17, 2010 | 01:26 PM

hbmtexas

Thread Starter

Teching In

Joined: Oct 2009

Posts: 6

Likes: 0

the reason im asking is cause my friend just wrecked his camero and said i could have whatever parts i need to make the conversion guess ill just use the pedal assembly

Jun 17, 2010 | 01:33 PM

JB_97ws6TA

TECH Fanatic

iTrader: (6)

Joined: Oct 2007

Posts: 1,118

Likes: 0

From: Central Valley, CA

if you are going to do the conversion I would take his pedal assembly with sensors and cut the pigtail for the clutch start switch out of his car. I would also take the y jumper that goes form the clutch anticipation switch to the brake switch.