Tranny explosion
#25
TECH Apprentice
Thread Starter
Join Date: May 2005
Location: Mount Sterling KY
Posts: 349
Likes: 0
Received 0 Likes
on
0 Posts
Ron/Phil the car is going to mike Harris in January to be put back together properly. Trans rebuild check the ring and pinion and have the drive train geometry set up right. Will also be working with you to get the boat into single digits!!!!
#27
TECH Apprentice
Thread Starter
Join Date: May 2005
Location: Mount Sterling KY
Posts: 349
Likes: 0
Received 0 Likes
on
0 Posts
Nah! I like the 200cc heads. just looking at other options to go with them. I like the Trickflows but I have a small cc chamber and higher compression. Helps move the boat off the line with low end torque.