Car is F'd, what to do?
Thread Starter
Teching In
Joined: Mar 2011
Posts: 6
Likes: 0
Alright, how about something like Rhino ramps? I just need to get under there enough to start working. I can always jack the car up more to slide the tranny out when the time comes. As it is, the car won't start, so I'm going to have to jack it up and slide the ramps under it.
Get ramps, jack stands... whatever to get the car up high enough to work on it pretty simple. then give'r ****. If jack stands wont get the car high enough put some wooden blocks under the jackstands.
i can fix it. didnt see where you were from
Thread Starter
Teching In
Joined: Mar 2011
Posts: 6
Likes: 0
I got the tranny out. I need some help. I'm not sure how the throwout bearing goes back and how to set up the clutch fork, so I took some pictures.
Is that set up right? The input shaft seal also got destroyed and I have no idea how to put the new one in. Help is appreciated. Thanks guys
Is that set up right? The input shaft seal also got destroyed and I have no idea how to put the new one in. Help is appreciated. Thanks guys
I assume that is the new throw out bearing? It needs to be connected to the pressure plate, but it needs to be turned around. I didn't change my seal when I had mine apart so I couldn't tell you what to do there. But that bearing isn't correct as is. If I'm not mistaken your going to need to pull everything else out and install that bearing into the pressure plate.
