I put a new tps sensor on my car and now when I want to open it up full throttle I feel like I'm having to push the gas threw the floor board any suggestion

 

Be more specific. Have you checked your new TPS for proper voltage at closed and wide open? Why did you need a new TPS in the first place?

 

My old one was bad and no I haven't how do you do that

 

How did you know your old one is bad?

Stock voltage with the key on, engine off on the blue signal wire should be between .2v and .9v (ideally ~.6v) at closed throttle and increase proportionally with throttle position about four more volts.

What do you mean "I feel like I'm having to push the gas threw the floor board." You need to be WAY more specific in order for us to help you. Specifically, how is the car acting?

 

I mean when I floor it I have stand on the gas pedal for it to hit wot and the other sensor was cracked were you plug into it

 

Have you checked to see if the tb blades open to WOT by hand? Also have you checked to see how far they open when you "Put it through the floor board"?

 

I will check it tom when there's light out side

 

Did it only start happening after you changed the tps, or did it do it before and that's why you changed it?

 

yes its been doing this since ive owned the car

 

Its opening almost all the way

 

When I push the gas peddle down

 

almost isnt all the way... time to upgrade your throttle body

 

Sorry but that's just WAY off and completely unnecessary.

OP, you need to check your TPS voltage before you do ANYTHING else.

 

need to find some one with a voltage checker and i will do that