Correct Sealant or Loc-Tite for Rocker Studs
#21
Thread Starter
On The Tree
iTrader: (2)
Joined: May 2008
Posts: 138
Likes: 0
From: Fort Lauderdale, FL
I should have been more clear. "Stock Ported Aluminum Castings". I have a very mild porting. Mostly a gasket match and polish. I don't think I would have gone far enough to hit the rocker stud holes. But just to be safe, I am sealing again. Couldn't find the stuff I used at work and it's special order only from NAPA where we order from. I might go with the Copper RTV since I have half a tube laying around.
Thanks for the reply's everyone!
Thanks for the reply's everyone!