Help!!

Reply Subscribe

Thread Tools

Search this Thread

Aug 20, 2011 | 10:29 PM

Luke1996ta

Thread Starter

TECH Apprentice

iTrader: (3)

Joined: Aug 2011

Posts: 318

Likes: 0

From: ottawa ohio

Help!!

I have been trying and trying and already broke one puller and I cannot get the balancer off my lt1 Anything helpful tips??

Aug 20, 2011 | 10:33 PM

bigj2717

TECH Addict

iTrader: (15)

Joined: Sep 2005

Posts: 2,062

Likes: 0

From: San Antonio, TX

Most of the balancers come of really easy just remove the three bolts. If it doesn't come off by itself use a three arm puller and make sure you only grab the balancer and not the hub. You can also spray some penetrating lube where the hub and balancer meet

Aug 20, 2011 | 10:41 PM

Luke1996ta

Thread Starter

TECH Apprentice

iTrader: (3)

Joined: Aug 2011

Posts: 318

Likes: 0

From: ottawa ohio

I already used a puller and it broke I have the three bolts off and the bolt that holds it on the crank

Aug 20, 2011 | 10:43 PM

bigj2717

TECH Addict

iTrader: (15)

Joined: Sep 2005

Posts: 2,062

Likes: 0

From: San Antonio, TX

There are only three bolts that hold the balancer on. You do not need to remove the center bolt.

Aug 20, 2011 | 10:46 PM

Luke1996ta

Thread Starter

TECH Apprentice

iTrader: (3)

Joined: Aug 2011

Posts: 318

Likes: 0

From: ottawa ohio

I have tried everything and no luck

Aug 20, 2011 | 11:14 PM

shbox

TECH Veteran

Joined: Dec 2008

Posts: 4,145

Likes: 61

From: Little Rock, AR

To remove the pulley, try this.

To remove the hub, try this. Sounds like you trying to pull the hub without putting something in the bolt hole to push against.

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last