Pulling engine...HELP!!

Reply Subscribe

Thread Tools

Search this Thread

Sep 26, 2011 | 09:44 PM

azlt

Thread Starter

Staging Lane

iTrader: (2)

Joined: Sep 2011

Posts: 80

Likes: 0

Pulling engine...HELP!!

Pulling my motor for a rebuild, EVERYTHING is disconnected, wires, exhaust, motor mounts are off, ect, ect.
All 6 of the bellhousing to motor bolts are removed and the car is an m6 so there shouldnt be anything else holding it on, I CAN NOT break the thing loose from the tranny, no matter which way i raise, lower or yank it, I am doing the pull from the top, and i already wish i went the out the bottom route..

Im too far into this to turn back now, been at it for two days, the thing is hooked to my cherry picker right now.
ANY idea you guys have on how to get this thing out?
thanks.

Sep 26, 2011 | 10:41 PM

shbox

TECH Veteran

Joined: Dec 2008

Posts: 4,147

Likes: 62

From: Little Rock, AR

Just about anyone that cannot separate the engine from a manual tranny has not pulled the clutch release fork from the throwout bearing.

Sep 26, 2011 | 11:29 PM

azlt

Thread Starter

Staging Lane

iTrader: (2)

Joined: Sep 2011

Posts: 80

Likes: 0

how is that done?? I hate this hanes manual.

Sep 26, 2011 | 11:55 PM

Catmaigne

TECH Fanatic

iTrader: (6)

Joined: May 2011

Posts: 1,241

Likes: 25

From: Conshohocken, PA

You grab the fork and pull it out after removing the slave. It's that easy.

Sep 27, 2011 | 12:46 AM

azlt

Thread Starter

Staging Lane

iTrader: (2)

Joined: Sep 2011

Posts: 80

Likes: 0

i knew that thing had to do with removing it, wow i couldove had this done in an hour if i knew this! Thank you so much guys!! you just taught a kid how to remove an engine!