Anyone have any luck with the Petris Enterprises vented optispark
#1
Staging Lane
Thread Starter
Join Date: Apr 2006
Location: belton,tx
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
Anyone have any luck with the Petris Enterprises vented optispark
I've done a lot of looking around and couldnt find anything bad on these guys, so I ordered one of their optis today. Seems like a good unit, but I wanted to see if there was anyone on this forum that had first hand experience with one of these optis. Any input is appreciated, thanks
#3
Staging Lane
Thread Starter
Join Date: Apr 2006
Location: belton,tx
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
here is the link to purchase it...
http://www.petrisenterprises.com/ind...product=701944
and here is the link with info...
http://www.petrisenterprises.com/ind...d=20&Itemid=26
http://www.petrisenterprises.com/ind...product=701944
and here is the link with info...
http://www.petrisenterprises.com/ind...d=20&Itemid=26
#6
I don't know about the optispark, but the included harness is using the wrong connector to the engine harness. Unless it is a custom (non-Delphi) mold, then the "keys" have been cut out of the connector. It tells me they are saving pennies to offer a lesser quality product.
The harness is also missing the proper attaching metal clip.
I would go as far as suggesting that the harness is not even assembled using production tooling (because production tooling is very expensive).
The harness should look like this:
The harness is also missing the proper attaching metal clip.
I would go as far as suggesting that the harness is not even assembled using production tooling (because production tooling is very expensive).
The harness should look like this: