Throttle body relocation?

Reply Subscribe

Thread Tools

Search this Thread

Mar 1, 2012 | 08:43 PM

#21

97Z28SS

TECH Fanatic

iTrader: (5)

Joined: May 2009

Posts: 1,290

Likes: 3

Here are some pics of my new setup, I was originally going to run the NO 860 elbow with my 58mm Holley tb but I wanted something eye catching that would confuse the average joe. I got lucky with my setup as I got the modified Victor E efi intake fully ported, water neck removed and drilled/tapped for the LT1 bolt pattern with the Edelbrock fuel rails from RamAir 95 for $530. Got my 42# injectors for $200, Accufab 1215cfm tb for $530 although I could have just used my 860 elbow $315 and Holley 58mm tb and saved the cost of the new tb.

http://i1110.photobucket.com/albums/...1Engine023.jpg

http://i1110.photobucket.com/albums/...1Engine022.jpg

http://i1110.photobucket.com/albums/...1Engine021.jpg

http://i1110.photobucket.com/albums/...1Engine021.jpg

Mar 3, 2012 | 10:02 AM

#22

zeeboost

Thread Starter

Staging Lane

iTrader: (1)

Joined: Apr 2007

Posts: 65

Likes: 0

From: Austin, TX

So it looks like my best bet will be to get the carburetor manifold along with a 90* elbow that will allow my lt1 t/b to bolt up. Cool, once again I have hope for this project. Thank you all for the replies.