RGSS

iTrader: (2)

Anybody has used this kit on an LT1 application?
ARP states this kit is for the SB with 1 piece rubber oil pan gasket.
No information regarding length of the bolts themselves.

1/2" bolts are a tad too short.
I would like to know if these are at least .625" long

Thanks for any input

RGSS

iTrader: (2)

I emailed ARP and was given the following answer. Just in case somebody else runs into this.


Hi Ricardo
Kit # 134-1802 = 14-pcs 1/4-20 x .625 long & 4-pcs 5/16-18 x .750 long.
RonF

warriorcustoms

iTrader: (10)

If its for a 1pc rear main seal sbc itll work fine They make 1pc oil pan gaskets for a 2pc seal motor & that wont work/fit!!! Bolts/studs should all be the same on Gen 1 & 2

ElkySS

iTrader: (6)

i have the stainless one. the studs are a tad too short for my liking but they work