Lets post pics torque arms
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
for awhile I wished I would have went with the S60. I can tell you the quality of the welds were great. It fit well. I cant tell you anything else since the car isnt up and going yet.
The canter is:
yukon thrubolt case
billet support
1350 yoke
Drag spool
motive gears
The canter is:
yukon thrubolt case
billet support
1350 yoke
Drag spool
motive gears
Yes it did fit well, I did have to take a step bit and drill the pan hard bolt hole out larger. That was the only issue as far as stock fitment.
The other issue I ran into was with my aftermarket BMR torque and the torque arm bracket from QP. The bracket on the BMR is pretty bulky and I had to trim some off of the QP bracket to make it work.
FWIW this wouldnt have been an issue with the stock torque arm or the Edelbrock torque arms I've seen. Im unsure about the rest.
The other issue I ran into was with my aftermarket BMR torque and the torque arm bracket from QP. The bracket on the BMR is pretty bulky and I had to trim some off of the QP bracket to make it work.
FWIW this wouldnt have been an issue with the stock torque arm or the Edelbrock torque arms I've seen. Im unsure about the rest.
