LT1-LT4 Modifications 1993-97 Gen II Small Block V8

Quarter mile times??????

Thread Tools
 
Search this Thread
 
Old 07-11-2012 | 04:01 PM
  #21  
Juicelt1z28's Avatar
Staging Lane
 
Joined: Jul 2011
Posts: 73
Likes: 0
Default

I actually seen this ad in Baltimore Craigslist and the mods that were listed by the op where the same mods listed on the ad,im on here through my cell phone so i cant post link but i never heard of a lsx intake manifold or a stage 2 comp cam on a lt1
Old 07-11-2012 | 04:13 PM
  #22  
ahritchie's Avatar
TECH Addict
iTrader: (1)
 
Joined: May 2010
Posts: 2,241
Likes: 1
From: Charlotte NC
Default

Originally Posted by Juicelt1z28
I actually seen this ad in Baltimore Craigslist and the mods that were listed by the op where the same mods listed on the ad,im on here through my cell phone so i cant post link but i never heard of a lsx intake manifold or a stage 2 comp cam on a lt1
Gotta love those craigslist "built" LT1 ads.....there's a local LT1 for sale with 657 HP supposedly "no reasonable offer refused":

http://charlotte.craigslist.org/pts/3072118706.html

This one is "super fast.. lots of recipes from Doug Herbert racing .. comes with Nos never used .. was fast enough without Nos but was bought to use"

http://charlotte.craigslist.org/pts/3072936905.html

LMAO
Old 07-11-2012 | 04:21 PM
  #23  
96capricemgr's Avatar
11 Second Club

iTrader: (1)
 
Joined: Sep 2004
Posts: 11,975
Likes: 14
Default

http://baltimore.craigslist.org/pts/3065681288.html
http://annapolis.craigslist.org/pts/3085994803.html

Aside from the fact the person who wrote that is either a crook or a raging idiot I would also question if the heads are instead LT4, not a big deal I would rather have LT1 anyway. The intake is likely LT1 since the LT4 was powder coated red.

Also interesting the OP says 94 but the picture shows an opto vent harness and what is probably a delco cap so it might have been converted to a vented opti setup.

Honestly I don't think I would pay but $1600 for the whole car if some of it was salvagable with the engine. The engine setup is a joke.
Old 07-11-2012 | 04:34 PM
  #24  
WS Sick's Avatar
TECH Fanatic
 
Joined: Jan 2004
Posts: 1,157
Likes: 0
From: Kingfisher Oklahoma
Default

I cringe every time I try to ask someone about a used LT1 car, you never know what response you will get.
Old 07-11-2012 | 04:53 PM
  #25  
ahritchie's Avatar
TECH Addict
iTrader: (1)
 
Joined: May 2010
Posts: 2,241
Likes: 1
From: Charlotte NC
Default

Originally Posted by WS Sick
I cringe every time I try to ask someone about a used LT1 car, you never know what response you will get.
Yea, I almost feel sorry for the OP...the blind leading the blind....pays to do your research before dropping cash on such a questionable build ...if only you came here first to ask questions FIRST; that ad should have been a huge red flag the seller has no earthy idea what he's talking about. Live and learn OP
Old 07-11-2012 | 05:04 PM
  #26  
bufmatmuslepants's Avatar
12 Second Club
iTrader: (3)
 
Joined: Mar 2007
Posts: 3,266
Likes: 47
From: Hampstead, NC
Default

Originally Posted by 96capricemgr
http://baltimore.craigslist.org/pts/3065681288.html
http://annapolis.craigslist.org/pts/3085994803.html

Aside from the fact the person who wrote that is either a crook or a raging idiot I would also question if the heads are instead LT4, not a big deal I would rather have LT1 anyway. The intake is likely LT1 since the LT4 was powder coated red.

Also interesting the OP says 94 but the picture shows an opto vent harness and what is probably a delco cap so it might have been converted to a vented opti setup.

Honestly I don't think I would pay but $1600 for the whole car if some of it was salvagable with the engine. The engine setup is a joke.
I saw that ad and thought it was a joke.

OP you got butt raped and your wallet stolen if you paid any more than $500 for that motor.

If your new to the game its best to post a question BEFORE dropping cash than after.
Old 07-11-2012 | 05:27 PM
  #27  
96capricemgr's Avatar
11 Second Club

iTrader: (1)
 
Joined: Sep 2004
Posts: 11,975
Likes: 14
Default

I just followed JuiceLT1z28's post that said there was a similar CL post.
I live near Green Bay so I don't look at Baltimore CL ads too terribly often.

It is sad how many completely tragic builds there are like this though especially given the amount of info available. I mean if whomever built that thing had even followed bad forum advise they could have likely done better.
Old 07-11-2012 | 05:55 PM
  #28  
forgedlt4's Avatar
TECH Apprentice
 
Joined: Apr 2006
Posts: 326
Likes: 0
Default

Originally Posted by leatherfacelt1
I just recently purchases a built lt1 for my 94 trans am it came with stage 2 comp cam(doesnt exist, could be any kind of cam. did you get a cam card?), lsx intake(Will not work on an LTX motor), lt4 heads benched and flow to ls6 heads( This could be true, but LS6 heads flow pretty good, so i doubt they match the specs.... did you get a flow sheet?), ls6 springs(possible, but springs are required with almost any cam install), hardened bearings (no such thing, perhaps you ment hardened pushrods? if thats the case, then thats like $40 and doesnt do anything but PREVENT a failure)

Also included
New opti distributor
New coil
New ignition module
New spark plugs
New alternator
New water pump
(all of that stuff get pricey if purchased new, id check those things to be sure they are in fact new)
Reminder I'm not tune for the cam, also stock 2.73 in the rear just curious anybody know any 1/4 mile times of this setup??????????

Its hard to say what it will run.

we dont know:
manual, or auto?
tire type?
headers or manifolds?
cold air intake?
exhaust?
any other mods? Ie roller rockers, throttle body, etc...
Old 07-11-2012 | 08:02 PM
  #29  
trilkb's Avatar
TECH Addict
iTrader: (4)
 
Joined: Jul 2005
Posts: 2,106
Likes: 78
Default

that picture certainly clears things up.

20$ says its a stock lt1 with a 355 rebuild kit.

And dude wanted a bike for it...Id give him a 120$ huffy from walmart.

I cringe every time I try to ask someone about a used LT1 car, you never know what response you will get.
TRUTH!!!!!!!! I hate asking anyone about their car that I dont know.

Last edited by trilkb; 07-11-2012 at 09:45 PM.
Old 07-11-2012 | 09:22 PM
  #30  
Jr.Samples's Avatar
TECH Regular
 
Joined: Oct 2011
Posts: 407
Likes: 2
From: Keller Tx
Default

*******? I gave a best guestimate based on the clusterfuck of information you provided. I am done with you.
Old 07-11-2012 | 09:23 PM
  #31  
96lt1m6's Avatar
TECH Junkie
iTrader: (31)
 
Joined: Jan 2006
Posts: 3,782
Likes: 2
From: LA$ VEGA$
Default

Seems like every other thread these days says, it has the CORVETTE engine and or it has Ls1 this Ls1 that... I cringe just hearing or reading that crap!!!!! It always appeals to the crowd that knows very little...........
Old 07-11-2012 | 09:25 PM
  #32  
WS Sick's Avatar
TECH Fanatic
 
Joined: Jan 2004
Posts: 1,157
Likes: 0
From: Kingfisher Oklahoma
Default

I just looked at an 02 WS^ I was really liking it until he told me it had the vette LS1 and t-56 in it. I still may buy it , but I can't look at him without thinking IDIOT..
Old 07-11-2012 | 09:46 PM
  #33  
trilkb's Avatar
TECH Addict
iTrader: (4)
 
Joined: Jul 2005
Posts: 2,106
Likes: 78
Default

2001 camaro z28...350ci v8



I could slap people for that alone.
Old 07-12-2012 | 10:36 AM
  #34  
93M6Formula's Avatar
TECH Fanatic
 
Joined: Aug 2008
Posts: 1,740
Likes: 2
From: Nebraska
Default

Old 07-12-2012 | 11:20 AM
  #35  
quik95lt1's Avatar
9 Second Club
iTrader: (7)
 
Joined: Dec 2008
Posts: 4,464
Likes: 12
From: Rhode Island
Default

should run mid 9's around 145mph............LOL..........seriously like said above if your enquiry was serious we will need much more VALID info to make a call on it
Old 07-12-2012 | 11:25 AM
  #36  
94Z28rag's Avatar
TECH Fanatic

iTrader: (10)
 
Joined: Jun 2008
Posts: 1,217
Likes: 1
From: West Chester, PA
Default

Originally Posted by trilkb
2001 camaro z28...350ci v8



I could slap people for that alone.
/thread.
Old 07-12-2012 | 11:28 AM
  #37  
Nick V.'s Avatar
TECH Enthusiast
iTrader: (1)
 
Joined: May 2011
Posts: 578
Likes: 2
From: Belvidere, NC Virginia Beach, VA
Default

if the car has a moderate amount of "real" work actually done, with 2.73s...maybe 14.xx?

other than that i dont know.

you were lied to about the car
Old 07-12-2012 | 11:52 AM
  #38  
DisasterFormula's Avatar
TECH Enthusiast
iTrader: (1)
 
Joined: Apr 2012
Posts: 637
Likes: 1
From: West TN
Default

It'll do the Kessel Run in 12 parsecs.
Old 07-12-2012 | 08:23 PM
  #39  
trilkb's Avatar
TECH Addict
iTrader: (4)
 
Joined: Jul 2005
Posts: 2,106
Likes: 78
Default

it'll outrun Imperial starships. Not the local bulk cruisers, mind you. I'm talking about the big Corellian ships
Old 07-13-2012 | 12:25 AM
  #40  
DisasterFormula's Avatar
TECH Enthusiast
iTrader: (1)
 
Joined: Apr 2012
Posts: 637
Likes: 1
From: West TN
Default

But you won't be going anywhere fast if the hyperdrive is broken. Might be able to get you to Bespin.



All times are GMT -5. The time now is 05:56 PM.