Throtle position sensor......?
#1
Staging Lane
Thread Starter
Join Date: Jan 2012
Location: illinois
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
Throtle position sensor......?
So I just swapped my 94 engine harness with a 95 harness due to some burnt wires. Not sure if this has anything to do with my current problem. I started the car it idles fine maybe a little high but as soon as I put it in gear it bogs down and runs real rough. Any ideas throttle position sensor....?
#2
TECH Veteran
How did you do that, seeing that the two harnesses are not the same? If you did not do any repining to C105 (which 94 cars don't have), only half of your injectors have power.
#3
Staging Lane
Thread Starter
Join Date: Jan 2012
Location: illinois
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
Yea I I ran the tan serial data signal to c220 but there is the orange and black which is trac control system spark retard in c105 but in the 94 the spark retard request is in c220 however it doesn't continue
#5
TECH Veteran
#6
Staging Lane
Thread Starter
Join Date: Jan 2012
Location: illinois
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
You are my hero I've been fighting this car for 3 months trans shop melted my harness on headers and a battle ever since I do have the computer from my 94 and the 95 which one should I use
Trending Topics
#9
TECH Veteran
If you got it running, I would say you probably got all the other wires mated up. It does not take much fuel to idle. Consider the newer engines that deactivate cylinders while you drive.