Spark Plug question

Reply Subscribe

Thread Tools

Search this Thread

Aug 7, 2014 | 09:39 AM

Capown

Thread Starter

TECH Enthusiast

iTrader: (5)

Joined: Jan 2008

Posts: 724

Likes: 0

From: San Antonio, TX

Spark Plug question

I have a friend building a 383 Stroker using the Edelbrock 2096 Top end kit. Compression is going to be at 9.5:1. going in a Street car with a built 700R4

Whats a good spark plug to run on this setup?

Aug 7, 2014 | 11:44 AM

bowtienut

TECH Fanatic

iTrader: (1)

Joined: Mar 2007

Posts: 1,685

Likes: 5

From: Bright, IN

Oh Lord..........is this an LT1?
With "Edelbrock 2096 Top end kit. Compression is going to be at 9.5:1", he might as well just go buy plugs from his lawn mower store.

Aug 7, 2014 | 12:38 PM

93M6Formula

TECH Fanatic

Joined: Aug 2008

Posts: 1,740

Likes: 2

From: Nebraska

Yeah I really hope you meant a GEN I small block.

Aug 7, 2014 | 12:55 PM

myltwon

TECH Addict

iTrader: (1)

Joined: Jul 2004

Posts: 2,965

Likes: 7

From: Palm Harbor, FL

Probably be a 315rwhp monster.

+1 on running pretty much any spark plug, doesn't even matter if its clean or gapped properly since the car likely won't be tuned either.

Aug 7, 2014 | 02:59 PM

Firebird383

Registered User

Joined: Aug 2014

Posts: 1

Likes: 0

I am the guy who is building the 383 stroker, pulled the the LT1 and returning with Gen 1 with HEI, any suggestions on what plug to run

Aug 7, 2014 | 03:21 PM

Capown

Thread Starter

TECH Enthusiast

iTrader: (5)

Joined: Jan 2008

Posts: 724

Likes: 0

From: San Antonio, TX

Yarp my bad! Not too familiar with these older setups. Can I get a MOD to move this to the Gen I smallblock section?

Aug 7, 2014 | 05:25 PM

bowtienut

TECH Fanatic

iTrader: (1)

Joined: Mar 2007

Posts: 1,685

Likes: 5

From: Bright, IN

Regardless of Gen 1 or Gen 2, we'd still need to know what use the engine will get, power output, extended? high power use, etc. Tapered seat or flat gasket plug?

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last