LS1TECH - Camaro and Firebird Forum Discussion
SBC-BBC-LT1-LT4 PERFORMANCE
LT1-LT4 Modifications
fly wheel looks off center?

LT1-LT4 Modifications 1993-97 Gen II Small Block V8

fly wheel looks off center?

Reply Subscribe

Search this Thread

Old

Oct 31, 2016 | 08:35 PM

#1

Thread Starter

Registered User

Joined: Oct 2016

Posts: 1

Likes: 0

Exclamation

fly wheel looks off center?

Hello i have a carburated lt1 engine that i am putting in an 84 chevy c10 pickup truck. anyways the motor has 100 thousand miles butt has new seals. water pump. gaskets eta. plus the motor has no modifications besides headers and intake manifold. my question is can the flywheel be offset? i know for sure its not bent but when bolted up the fly wheel is closer to right side of the block then the left. like two lines that are not parallel. plz answer back and thanks. this is the first time i have seen an engine out of a car and complete.

Old

Oct 31, 2016 | 08:49 PM

#2

TECH Apprentice

iTrader: (3)

Joined: Jul 2008

Posts: 374

Likes: 0

From: Morinville, Alberta, Canada

Default

Rotate the motor by hand and see if it wobbles side to side.
Be the quickest way to confirm if it's off center or not

Old

Nov 1, 2016 | 11:17 AM

#3

TECH Veteran

Joined: Apr 2008

Posts: 4,985

Likes: 112

Default

is it the original flywheel or replacement?

it should be centered

Attached Thumbnails

fly wheel looks off center?-clutch-inst-4-flywheel.jpg

fly wheel looks off center?-clutch-inst-5-zoom-pp.jpg

Old

Nov 1, 2016 | 11:53 AM

#4

Village Troll

iTrader: (2)

Joined: Oct 2002

Posts: 11,111

Likes: 598

From: Jackstandican

Default

Op, post a pic of what you're talking about.

Reply Subscribe

First
Prev
1 / 1
Next
Last

All times are GMT -5. The time now is 11:29 PM.