New 409SS 3" single exhaust
Car originally came with PS catless Y pipe and Borla adj catback. It has since gone through a modified Borla catback, then tried to "fix" the merge in the PS midpipe.
First midpipe change in an attempt to smooth the merge. You can see the original merge here:
Tried to cut off as much as I could and stuff on a 4" dia Flowmaster "race" muffler followed by a 3" glasspack:
Placed an order for some pipe and 3" Vband:
Couple days later planning this out I came up with this. My friend had a good idea for a better Y merge design.
I took the old exhaust off last Thursday and had a fully mocked up/tacked system last night ready for welding. All work was done with the car on jackstands and nothing more than a 4" electric cutoff wheel and a tape measure. The dark areas are where I needed to heat the pipe to dent it for clearance. The DS dent is for the typical LT1 floorboard area. the other area is for the TA clearance.
I have a Watts Link and can confirm that the V-Band rings can be removed between the floor and Watts link. the goal is to have the rear section removable to run a full size muffler for winter to be quiet then swap out for a more aggressive system for summer.
Exhaust is currently welded and I plan to get it on the car and running by tomorrow.
Update: Videos of both setups
Last edited by smitty2919; Apr 21, 2017 at 01:57 PM.
This is the popping I was trying to get rid of at the 0:24 mark and 0:57 mark.
The new merge REALLY smoothed that out. I will never build a conventional merge again.
I will work to get a video this weekend.
Trending Topics
The Best V8 Stories One Small Block at Time




