LT4 roller rockers

Reply Subscribe

Thread Tools

Search this Thread

Jul 25, 2005 | 06:49 PM

LonnieJ71

Thread Starter

Teching In

Joined: Jul 2005

Posts: 18

Likes: 0

From: Dora, Alabama

Will the LT4 rollers rockers work on my LT1 studs?

I have a set of the LT4 roller rockers, will they fit and work on a set of LT1 heads? Arent the studs for the lt4s metric or a little off from the lt1s? Are they as good as the cranes or other 1.6s out there? and advice would be appreciated. thanks

Last edited by LonnieJ71; Jul 25, 2005 at 07:49 PM. Reason: no replies

Jul 25, 2005 | 08:18 PM

dhdenney

TECH Veteran

iTrader: (53)

Joined: Feb 2004

Posts: 4,433

Likes: 0

From: Monticello, Kentucky

I'm sure you can find heads specs somewhere that would tell the stud size but I would be 99% sure that the LT4 heads would have had 3/8" studs anyway. 7/16" is usually for the aftermarket stuff. As far as reliability in comparison to other manufacturers, I say you can't go wrong with OEM stuff. They sell the rockers in the LT4 conversion kits.

Jul 25, 2005 | 11:03 PM

LonnieJ71

Thread Starter

Teching In

Joined: Jul 2005

Posts: 18

Likes: 0

From: Dora, Alabama

Thanks I found out that the factory ones are 10mm studs and the ones in my LT1 are 3/8". Im not sure if it is that big of a differance between the two.

Jul 26, 2005 | 03:40 AM

dhdenney

TECH Veteran

iTrader: (53)

Joined: Feb 2004

Posts: 4,433

Likes: 0

From: Monticello, Kentucky

Hmm did not know that. Studs are readily available and not really all that expensive so you can always change them. Good luck.

Jul 28, 2005 | 10:58 PM

qcworm

On The Tree

iTrader: (2)

Joined: Jul 2004

Posts: 159

Likes: 0

can you please send me a pic of the bottom of 1 of your rockers, i need a clear pic to do some comparison to mine please. to qcworm2002@yahoo.com

thank you

Reply Subscribe