Turn Signal Switch broken?
Thread Starter
Teching In
Joined: Nov 2005
Posts: 2
Likes: 0
Turn Signal Switch broken? My turn signal was working fine until the other night... I pushed it down to signal a left turn, and when I completed my turn, the signal turned off. A few minutes later I tried to signal another turn, but the **** was just hanging loosely, I didn't feel any resistance at all.... and when I lifted it up (where it would normally signal a right turn) it just falls back down.
All the other switches work (wipers, "brights", etc.) but it just doesn't signal turns anymore.
Thanks.
All the other switches work (wipers, "brights", etc.) but it just doesn't signal turns anymore.
Thanks.
TECH Enthusiast
Joined: May 2005
Posts: 669
Likes: 0
From: Charlotte, NC
unless the lever itself broke (look to make sure that it's still holding into the switch ok) your going to have to dig into the column and see what happened. This is not something that I recommend you do yourself due to the need of special tools and disabling of the air bags.
Possible causes are the switch, switch cam, lever arm or bolt ect ect ect. Only one way to find out.
Possible causes are the switch, switch cam, lever arm or bolt ect ect ect. Only one way to find out.
