Carb intake question
To run a standard intake you must either convert the heads to SBC bolt spacing, or the intake to LT1 bolt spacing. They also make lt1/lt4 specific carb intakes, but those are all dual plane setups
Intake To The guys who run a super victor:
Do you mill off the water crossover and weld them up?(On a std sbc intake)
and the tap the heads for the std sbc intake???
What do i have to do??????
Do you mill off the water crossover and weld them up?(On a std sbc intake)
and the tap the heads for the std sbc intake???
What do i have to do??????
Originally Posted by LS1DUCE
To The guys who run a super victor:
Do you mill off the water crossover and weld them up?(On a std sbc intake)
and the tap the heads for the std sbc intake???
What do i have to do??????
Do you mill off the water crossover and weld them up?(On a std sbc intake)
and the tap the heads for the std sbc intake???
What do i have to do??????
It's easier to make the intake work than change the heads.
Send me a e-mail if you need any info on this.
Bret
