Solid Roller Pushrods-What part number?
Thread Starter
Joined: Feb 2003
Posts: 2,145
Likes: 133
From: East Chatham, New York
Solid Roller Pushrods-What part number? Anyone have a part number or a pushrod length to use as a guide? Or is there an 'off the shelf' solidr roller pushrod? I guess I have to know if it's a smaller base circle cam (which I don't know at this point since it's a slightly used cam). I have just purchased a custom Cam Motion Solid Roller cam for my new 383 motor. It came with Crane solid roller lifters. Did you solid roller guys end up having to measure for some custom sticks?
Originally Posted by mightyquickz28
Anyone have a part number or a pushrod length to use as a guide? Or is there an 'off the shelf' solidr roller pushrod? I guess I have to know if it's a smaller base circle cam (which I don't know at this point since it's a slightly used cam). I have just purchased a custom Cam Motion Solid Roller cam for my new 383 motor. It came with Crane solid roller lifters. Did you solid roller guys end up having to measure for some custom sticks?
Best thing to do is get a push rod length checker and then roll it over to check for geometry & roller travel over the top of the valve.
I've got Crane 11522's with T&D shafties...I'm using Trick Flow chromoly push rods at a length of 7.9".
P
I've got Crane 11522's with T&D shafties...I'm using Trick Flow chromoly push rods at a length of 7.9".
P
