ET Performance LT1 Heads (PICS)
Thread Starter
TECH Addict
iTrader: (10)
Joined: Oct 2004
Posts: 2,339
Likes: 0
From: TheNew home of the Cowboys
ET Performance LT1 Heads (PICS) 
The chamber sizes is 58cc. They are very close to what stock is because not much material comes out of the chamber. The port volume is 207cc on the intake. 2.02 IV 1.60 EV Flow low-mid 280's
Thread Starter
TECH Addict
iTrader: (10)
Joined: Oct 2004
Posts: 2,339
Likes: 0
From: TheNew home of the Cowboys
Well they are up for sale but I had a CC306 that I was going to install with them but I sold it to. Pretty much going big inch SBC now, nothing for the streets.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Thread Starter
TECH Addict
iTrader: (10)
Joined: Oct 2004
Posts: 2,339
Likes: 0
From: TheNew home of the Cowboys
Not a sales thread that would be against forum rules 
I got the heads and a digital camera and just now been able to get them posted up, it is coinsidence that at this time they are for sale. I just wanted to share the work a site sponsor (ET Performance) does for the LT1 so it is known they do AWESOME work. 
I got the heads and a digital camera and just now been able to get them posted up, it is coinsidence that at this time they are for sale. I just wanted to share the work a site sponsor (ET Performance) does for the LT1 so it is known they do AWESOME work. I guess I found out who i will have do my heads if I stay with the LTx castings. I need 8.5/1 compression so im not sure that I will be bale to easily use the stock castings yet.
