my cutout dilemma..
#1
TECH Regular
Thread Starter
iTrader: (3)
Join Date: Jul 2006
Location: Conshohocken, PA
Posts: 420
Likes: 0
Received 0 Likes
on
0 Posts
my cutout dilemma..
So heres the dilemma.. Hooker LTs, Hooker off road Y pipe, Hooker Cat Back exhaust.... and.. emissions. So I HAD to have a cat in there.. not necessarily in the stock location because i can pull a few legs.. but there had to be one. So i had it put in the I pipe.. pretty much as close as i could get to the Y-pipe which is say 3-6" away. So there really is no room on the I pipe to install this cutout so i was thinking....
Cut the y-pipe down a little and cut the I pipe down a little where they meet to fit the cutout in, clamp it, and use it to bridge the gap between them... think it will work?
i can get pictures if you guys dont understand what im explaining.. im not usually good at it
Cut the y-pipe down a little and cut the I pipe down a little where they meet to fit the cutout in, clamp it, and use it to bridge the gap between them... think it will work?
i can get pictures if you guys dont understand what im explaining.. im not usually good at it
#5
TECH Regular
Thread Starter
iTrader: (3)
Join Date: Jul 2006
Location: Conshohocken, PA
Posts: 420
Likes: 0
Received 0 Likes
on
0 Posts
im gonna bridge the y-pipe to the exhaust with the cutout.. the only o2 sensors back there are on the headers so theres no way its too close being after the y-pipe.. heres a picture of where i plan to put it...