Codes and electricity
Codes and electricity I´m setting a few codes and beleve it´s because the wire loom is getting ground somewhere in the negine bay and messing with the sensors
Where is a typical place for the loom and computer to get ground?
It would be better to say what codes i don´t have
I have codes 12-16,21-28,32-32,36,41-46,51-53,55,61-69 and 71
I have removed the AC,Smog system
Err12: No DRP Pulses
Err16: Lo-Res Fail
Err26: QDM3 CCP Electrical Fault
Err27: QDM3 EGR Electrical Fault
Err28: QDM3
Err36: Hi-Res Fail
Err41: EST Open
Err42: EST Grounded
Err43: ESC Fail
Err53: System Voltage Problem
These are the codes i´m linkning to my fault
Ignition system is compleatly new,from ignition to plugs,Fuel pump and injectors,Fuel filter new ect...
i know about the checksum error but that is my fault and i have fixed that,but still the same
Where is a typical place for the loom and computer to get ground?
It would be better to say what codes i don´t have
I have codes 12-16,21-28,32-32,36,41-46,51-53,55,61-69 and 71
I have removed the AC,Smog system
Err12: No DRP Pulses
Err16: Lo-Res Fail
Err26: QDM3 CCP Electrical Fault
Err27: QDM3 EGR Electrical Fault
Err28: QDM3
Err36: Hi-Res Fail
Err41: EST Open
Err42: EST Grounded
Err43: ESC Fail
Err53: System Voltage Problem
These are the codes i´m linkning to my fault
Ignition system is compleatly new,from ignition to plugs,Fuel pump and injectors,Fuel filter new ect...
i know about the checksum error but that is my fault and i have fixed that,but still the same
