delteq direct

Reply Subscribe

Thread Tools

Search this Thread

Jan 23, 2007 | 06:51 AM

TAdriven98

Thread Starter

Launching!

iTrader: (2)

Joined: Feb 2004

Posts: 229

Likes: 0

From: Sarasota

delteq direct

Had a somewhat successful installation sunday drove for a whole two days now it runs for about 5 mins then stumbles and stalls. Checked the plugs, wire connections, grounds. What else to check?

Jan 23, 2007 | 10:05 AM

titter

TECH Apprentice

iTrader: (5)

Joined: Sep 2005

Posts: 349

Likes: 0

From: Fort Myers, FL

Have you checked the fuel pressure? Also have you changed the fuel filter? Coil could also be bad, but normally that isn't noticed until higher rpm.

Jan 23, 2007 | 11:07 AM

bmccrary

TECH Regular

Joined: Oct 2005

Posts: 431

Likes: 1

From: Lexington, NC

When my O2 sensors went bad, the car ran fine for the first 5 minutes or so. But that was just until the engine got heat in it, then it went freaking nuts. The car never stalled on me, though I thought it was going to several times. Check the 02's.

-bryan

Jan 23, 2007 | 11:25 AM

RealQuick

TECH Junkie

iTrader: (14)

Joined: Feb 2004

Posts: 3,970

Likes: 15

From: MA

delteq spk plug wires suck... i bet its them. You wouldnt be the first or the last to have brand new delteq wires **** after little use.

Jan 24, 2007 | 12:41 PM

TAdriven98

Thread Starter

Launching!

iTrader: (2)

Joined: Feb 2004

Posts: 229

Likes: 0

From: Sarasota

I dont think its a fuel issue cause it runs for a few minutes perfect then it starts searching for an idle and it gets worse and worse til it dies if it was fuel I think it would just stall out right?

Jan 25, 2007 | 05:26 AM

UnitZ28

On The Tree

Joined: Aug 2006

Posts: 173

Likes: 0

your opti sensor is probably bad I had the same problem, changed the opti and it was fine... til the head gasket went ... the wires do suck but they arent going to make the car stall

Reply Subscribe