Finished header install
Thread Starter
Teching In
Joined: Dec 2005
Posts: 21
Likes: 0
Finished header install so on Saturday i put a set of edlebrock headers on my 95 lt1 went pretty smooth took about 5 and half hours to do. but i am getting a leak on the top on to headers were they bolt on. i used mr gasket copper header gaskets and it is still leaking. the header were used but i didn't think they were warped at all, but it could be possible. should i try using a different gasket like a regular one just wondering what you guys thought. all bolts are tight.
Thanks For any help
Thanks For any help
Teching In
Joined: Aug 2006
Posts: 18
Likes: 0
From: Connecticut
I have had nothing but headaches with the copper gaskets. I could never get them to seal right . I check to see if the flanges were warp at all , they were not. I would use either the stock style replacements from Fel Pro or GM. Or if pick up a set of Mr Gasket Ultra seals .
TECH Enthusiast
Joined: Feb 2006
Posts: 517
Likes: 0
I've had good luck with SCE copper gaskets:
http://store.summitracing.com/partde...5&autoview=sku
So far, they're the only gaskets I've used that worked.
I think your flanges are warped.
http://store.summitracing.com/partde...5&autoview=sku
So far, they're the only gaskets I've used that worked.
I think your flanges are warped.
