Good hyd. roller lifters...
#1
Launching!
Thread Starter
iTrader: (3)
Join Date: Feb 2004
Location: Walnutport, PA
Posts: 229
Likes: 0
Received 0 Likes
on
0 Posts
Good hyd. roller lifters...
i cant find what im looking for while searching soo here it goes..
does anybody know of a good set of hydrolic roller lifters that are at a decent price.
they need to be for a factory roller block (roller 350) with a small base circle cam.
ive read about the LS7 and LSx lifters being used in LT1 blocks, and SBC's, but i am not sure if they are any longer than stock height, or if the block needs mods.
i am running a SBC 535/550 voodoo roller, and as far as im concerned, stock lifters are not recommened?
so what ever you guys run or what you suggest would be awesome.
thanks.
aaron
does anybody know of a good set of hydrolic roller lifters that are at a decent price.
they need to be for a factory roller block (roller 350) with a small base circle cam.
ive read about the LS7 and LSx lifters being used in LT1 blocks, and SBC's, but i am not sure if they are any longer than stock height, or if the block needs mods.
i am running a SBC 535/550 voodoo roller, and as far as im concerned, stock lifters are not recommened?
so what ever you guys run or what you suggest would be awesome.
thanks.
aaron
#2
In-Zane Moderator
iTrader: (25)
Thats what i hear is the LS7s work, i have .520 .540 lift on my stockers and it works fine, but it is a comp cam and i didnt know of this till after the install, i got lucky, there are verticle bar lifters i have seen for 230$ or so, they will work fine if you dont find anything else.