Pacesetter LT Install Pics
Pacesetter LT Install Pics Does anyone have any good pics of the Pacesetter LTs on an LT1? I'd like to see some good underneath shots of all this mess before I jump on mine.
-Rick
-Rick
I don't have any pics, but as far as fitment is concerned they go right in and have plenty of ground clearance...About 5 or so of my friends have them on their cars..... Be sure to lift the car up really high if your doing it on the ground. Better yet put the back of the car on truck jack stands and raise the front up as high as the jack will go. TRUST ME. And your gonna have to be sure to keep the sterring wheel locked in place and remove the steering shaft to put in the LT's.....Good Luck PM if ya have questions.....
James
James
I'd appreciate some pics and whatnot, I really hate running into surprises when doing an install like this. My main concern is what everyone talks about, having to notch the k-member... and the LTs banging the floorpan... Do yall have this problem?
-Rick
rmartin5@email.tjc.edu
-Rick
rmartin5@email.tjc.edu
On The Tree
Joined: Sep 2004
Posts: 178
Likes: 0
From: ALBUQUERQUE, NM
I'd appreciate some pics and whatnot, I really hate running into surprises when doing an install like this. My main concern is what everyone talks about, having to notch the k-member... and the LTs banging the floorpan... Do yall have this problem?
-Rick
rmartin5@email.tjc.edu
-Rick
rmartin5@email.tjc.edu
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Five Reasons the Camaro Was the Most Pivotal Player in the Pony Car Wars 2.0
Brett Foote
10 Reasons the LS7 Is GM's Most Extreme Naturally Aspirated V8 Engine Ever
Verdad Gallardo Where do ya'll get the muffler clamps used to connect the headers to th y-pipe and the y-pipe to the cat back? I've been searching for them around Tyler and haven't found any.
-Rick
-Rick
yep right here, everything you need OP https://ls1tech.com/forums/lt1-lt4-modifications/783145-my-new-exhaust-dyno-numbers.html (I am in the white shirt)
On The Tree
Joined: Sep 2004
Posts: 178
Likes: 0
From: ALBUQUERQUE, NM
I just installed a set today - I had also just installed new motor mounts and the engine has not settled yet---- I don't know if the interferance was due to this - but I did run into a small amount of interferance on the passenger side floor board right at the header collector weld - I had to drift the floorboard in about 1/8 to 1/4 inch and also bend the factory heat shield in the same place then it cleared no prob. I replaced a set of Edelbrock shorties and overall I am really impressed with the quality of the Pacesetters so far - I was also worried abt ground clearance but they tuck up under the car nicely - I will snap a few pics tomorrow.
