skrieg1

Just installed a street twin. Installation was flawless. Chatter is awful so much dashboard vibrates up and down. Mcleod says this is rare and break it in to see if it goes away. Does anyone have any insight? Gears are 410.

Thanks

Gen414

iTrader: (38)

Couple guys to look for and should be chiming in are thesource, TICK, and taner. I have found those 3 guys have more info on our setups than most.

Good luck

85MikeTPI

iTrader: (9)

On a LSx motor? How many miles? My street twin chattered for about 200 of the 500 breakin miles. Did you make sure to align the marks on the flywheel, mid-plate, and PP ?

Chris05ssTruck

iTrader: (9)

Mine chatters a lil but nothing like that. It's getting better w/ miles tho.
Something dosent sound right.
U know how to drive it correctly? Sounds like the clutch is grabbing and ur still "riding" the clutch out.

transAm-98

iTrader: (1)

My Mcleod twin is very smooth. a little grabby but no chatter. Give it a few more miles and see what happens.

skrieg1

Forgot to mention. Install was in a Lt1. Installation was flawless, and everything was done perfectly. I'll put some miles on it like they recommend. I hope like hell it goes away.

10seclsxfox

it could be ur pinion angle on your rear end mine did the same thing with a mcleod set up it ended up being the rear end i would have you rear end checked out