ok i helped a friend out we pulled his motor and trans and i told him he needed a clutch so he bought a ram clutch and had the flywheel surfaced and we put it all in came with pressure plate and throw out bearing after it was installed it will not go in to reverse unless you start in reverse but all other gears work fine i think he is going to have to get an adjustable slave cylinder and help would help me out. thanks

 

keep on bleeding the clutch, it may take a couple of bottles of brake fluid, good luck

 

If the flywheel was resurfaced you need to shim the slave cylinder how ever much was taken off the flywheel.

I believe you need an adjustable master cylinder with the ram clutches.