BMR crossmember not fitting?
#1
On The Tree
Thread Starter
iTrader: (5)
Join Date: Jul 2007
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
![](https://ls1tech.com/forums/images/ranks/ls1tech10year.png)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
I finally got around to completing my m6 and was finishing up the install. I ordered this crossmember from a member on here for an m6, but it does not bolt up at all to the transmission. (The mount is at too high of a position). I tried bolting up a stock m6 crossmember and it bolted up just fine. Are you supposed to use a special transmission mount with bmr crossmembers?
I also attached a picture to show the m6 and the bmr. It looks like you just do not use the mount on the tranny, is that right?
Thanks
I also attached a picture to show the m6 and the bmr. It looks like you just do not use the mount on the tranny, is that right?
Thanks
![](https://s88.photobucket.com/albums/k188/bigboi69_2006/crossmember-1.jpg)
Last edited by pooker; 04-03-2009 at 03:00 PM.