Stock Measurement ???
#1
Staging Lane
Thread Starter
iTrader: (3)
Join Date: Mar 2005
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
Stock Measurement ???
Can anyone tell me what the stock distance is from the crankshaft side of the flywheel to the spring fingers of the pressure plate. I want to make sure these are right so I don't have any engament/disengement issues. Thanks
#2
TECH Addict
iTrader: (9)
Not sure what you're trying to do. You can use the sticky post to see if you're slave is going to be correct for proper (dis)engagement, or if you'll need to shim it.
https://ls1tech.com/forums/manual-tr...need-shim.html
https://ls1tech.com/forums/manual-tr...need-shim.html
#3
Staging Lane
Thread Starter
iTrader: (3)
Join Date: Mar 2005
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
OK since I got no help from the group maybe I can offer some back. First I want to thank Jeremy at SPEC.
The stack height is 3.120. That is measured from the crankshaft side of the flywheel to the tip of the pressure plate fingers.
The standard flywheel thickness is .820
The stack height is 3.120. That is measured from the crankshaft side of the flywheel to the tip of the pressure plate fingers.
The standard flywheel thickness is .820