replaced slave cylinder and still have no pedal @ high RPMs
#1
Launching!
Thread Starter
iTrader: (12)
Join Date: Nov 2007
Location: Liberty, Ohio
Posts: 236
Likes: 0
Received 0 Likes
on
0 Posts
replaced slave cylinder and still have no pedal @ high RPMs
when I bought my 2000 SS it had pedal pressure issues, I figured it was the slave so I pulled the trans and replaced it with a new stock replacement and put a tick shift remote bleeder on it, if I did any full gear pulls on it as soon as I shift into the next gear I miss it cause the pedal just goes to the floor, which it was doing before, would this be cause my a bad master cylinder?.......need help and I wanna go to the track this friday....thanks
#2
Staging Lane
Join Date: Mar 2010
Location: Temecula, CA
Posts: 94
Likes: 0
Received 0 Likes
on
0 Posts
I just installed the Tick M/C because I am having the same problems as you. Mine is still doing it after the Tick M/C install so replacing the slave is next for me. It's either the M/C or a pressure plate/clutch issue. I would change out the M/C first since you dont have to drop the trans and see if that fixes it.
#3
Launching!
Thread Starter
iTrader: (12)
Join Date: Nov 2007
Location: Liberty, Ohio
Posts: 236
Likes: 0
Received 0 Likes
on
0 Posts
I just installed the Tick M/C because I am having the same problems as you. Mine is still doing it after the Tick M/C install so replacing the slave is next for me. It's either the M/C or a pressure plate/clutch issue. I would change out the M/C first since you dont have to drop the trans and see if that fixes it.
#6
Staging Lane
Join Date: Mar 2010
Location: Temecula, CA
Posts: 94
Likes: 0
Received 0 Likes
on
0 Posts