LS1TECH - Camaro and Firebird Forum Discussion

Manual Transmission T56 | T5 | MN12 | Clutches | Hydraulics | Shifters

What spline is the viper shaft?

Thread Tools
 
Search this Thread
 
Old 05-24-2010 | 11:00 AM
  #1  
robsquikz28's Avatar
robsquikz28
Thread Starter
TECH Veteran
iTrader: (246)
 
Joined: Mar 2008
Posts: 4,984
Likes: 0
From: Chicago/Crown point
Default What spline is the viper shaft?
Im trying to figure out if a stock driveshaft will work? Is it the same as a stock t56?
Reply Like
Old 05-24-2010 | 01:06 PM
  #2  
bigj2717's Avatar
bigj2717
TECH Addict
iTrader: (15)
 
Joined: Sep 2005
Posts: 2,062
Likes: 0
From: San Antonio, TX
Default
You need a different yoke on the drive shaft. Viper output shaft is 30 spline stock f-body is 27. I believe that Tick will sell just the yoke you need
Reply Like
Old 05-24-2010 | 09:24 PM
  #3  
NVR_SPDS's Avatar
NVR_SPDS
TECH Addict
iTrader: (39)
 
Joined: Aug 2003
Posts: 2,129
Likes: 3
From: Virginia
Default
+1 ^^ When i went with my RPM built T56 (Viper spec) i got a yoke for the stock driveshaft. Youll need the yoke, and a conversion u joint. I also had my driveshaft balanced afterwards, just to make sure it was right.
Reply Like
Tags
Back to Subforum
Manual Transmission
View Next Unread
T56 trouble going into 5th




Advanced Search
Quick Reply: What spline is the viper shaft?


Reply Closed Thread Share

All times are GMT -5. The time now is 08:49 AM.