MUSTANGBRKR02

iTrader: (91)

So i was trying to remove the 5-6th driven gear from my t56 with the make shift puller in the rebuild thread and it broke teeth off of this gear. The gear is really on there good.

Where can i get a t56 gear puller from?

Thanks

I have searched high and low.

thesource

iTrader: (60)

Snap On makes a damn good one but you'd better be ready to spend some $$$$ for it.

jmd

iTrader: (4)

https://ls1tech.com/forums/13010740-post5.html

https://ls1tech.com/forums/13011339-post6.html

85MikeTPI

iTrader: (9)

FWIW, I found that most of the trouble is caused by the puller slipping on the gears. I tighten a hose clamp around the claws to hold them firmly in place and haven't had any problems..

MUSTANGBRKR02

iTrader: (91)

Thanks for the help huys. I will have another look around.

MUSTANGBRKR02

iTrader: (91)

Thanks Mike, I should have thought of this as I do it while torqueing aircraft parts all the time.

396D1SS

iTrader: (21)

i made a custom one. pm me if you would like the specs.