Stumped on swap wiring?
07-21-2010, 08:47 PM
#1
11 Second Club
Thread Starter
iTrader: (14)
Join Date: Aug 2008
Location: Hendersonville TN
Posts: 444
Likes: 0
Received 0 Likes
on
0 Posts
Stumped on swap wiring? I've gone through just about every thing I could find on this site on how to do the swap from A4 to M6. I have everything sorted out except the cruise control.
We did the fullest extent of a swap you could do to include the hard parts, wiring harness, and even computers. Like I said, everything works but the cruise. I have the switch on the pedal with an open connector. I believe it's a black/w white and a tan wire coming out of it. Where do I have to splice these in to complete a circuit?
We did the fullest extent of a swap you could do to include the hard parts, wiring harness, and even computers. Like I said, everything works but the cruise. I have the switch on the pedal with an open connector. I believe it's a black/w white and a tan wire coming out of it. Where do I have to splice these in to complete a circuit?
07-22-2010, 12:06 PM
#2
It would help to know what you're working on.
The clutch pedal anticipation switch, AKA clutch pedal position switch should have a blk/white wire and a gray wire.
Blk/white goes to ground, gray goes to C1 32 at the computer harness.
The clutch pedal anticipation switch, AKA clutch pedal position switch should have a blk/white wire and a gray wire.
Blk/white goes to ground, gray goes to C1 32 at the computer harness.
07-22-2010, 12:21 PM
#3
