need help with master cylinder line
#1
On The Tree
Thread Starter
iTrader: (2)
Join Date: Jan 2004
Location: San Diego, CA
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
need help with master cylinder line
I just swapped my master because the old one was spewing brake fluid all over my floorboard and clutch pedal. Anyway, I can't get this steel braided line back into the slave. I followed the steps in install u, opening the bleeder to relieve system pressure, but still no luck. How hard do you push on this thing? Do I need to do anything with the little white plastic ring when I'm pushing the line back into the trans? HELP!