HELP! ls1 to T101 adaptor????
#1
Teching In
Thread Starter
iTrader: (7)
Join Date: Oct 2007
Location: Los Angeles
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
HELP! ls1 to T101 adaptor????
I just bought a T101 4 speed, straight cut geared dog box for my LS6 powered RX7. The shop i bought the tranny from sold me a used quartermaster bellhousing from an older style chevy motor. bolt pattern will work -1 bolt, but the bellhousings inside is smaller, and it wont go around my flywheel (im not changing my exedy twin disk flywheel/clutch setup).
is there a bellhousing that will fit an ls1 to a t101, or an adaptor plate that will bolt onto the back of a t56 bellhousing to allow a t101 to bolt up?
Thanks!
Michael
is there a bellhousing that will fit an ls1 to a t101, or an adaptor plate that will bolt onto the back of a t56 bellhousing to allow a t101 to bolt up?
Thanks!
Michael
#5
Staging Lane
iTrader: (3)
Join Date: May 2009
Location: NJ
Posts: 91
Likes: 0
Received 0 Likes
on
0 Posts
I know this thread is old -but I was searching T101 trans on the site and figured I'd put at least one solution for other people that actually use the search feature.
Quicktime makes one...
http://www.quicktimeinc.com/products.html
so does pace performance -but you have to change your flywheel:
http://paceperformance.com/index.asp...&ProdID=228851
Quicktime makes one...
http://www.quicktimeinc.com/products.html
so does pace performance -but you have to change your flywheel:
http://paceperformance.com/index.asp...&ProdID=228851
#6
TECH Senior Member
iTrader: (7)
The T101 does not require a special flywheel. Flywheels don't care what transmission is being used as long as the clutch disk splines match the splines on the input shaft of the transmission.
Andrew
Andrew
#7
if the bolt patern for that specific clutch dosent line up with your flywheel u will need to use their flywheel